How to Solve a Water Heater in a Climbing Space

If your home has a crawl space, you have a leaky water heater in a crawl space. The water heater has been sitting there for quite some time, and now the water is hot in Boise Idaho. What do you do? First, you can heat the water with a heater, but that would be the least expensive solution. Now, you need to figure out how to seal the heater so that it stays hot longer and doesn’t leak any water.

Japan, Island, Nagasaki, Kyushu

Water Heater in a Climbing Space

Most water heaters are vented to the outside, so that they don’t blow coolant all over the room when they are not running. That coolant usually makes the water heater a little chilly on the inside, especially if you live in a humid climate, so the best thing to do is make sure that you buy a water heater with an air release valve. These valves are installed right at the water heater and let coolant escape easily as the heater turns on and off. There are some older water heaters that don’t have these valves, and if yours does, you just need to buy one with an air release valve of some kind. When you find one like this, you’ll need to replace it so that it vents properly.

Final Words

Some people are afraid of making a hole in their wall, but when you are doing something as large as a water heater, you can’t afford to make a mistake. Even though a hole in your wall might seem like a bad thing at first, it will actually save you money in the long run because it means that the water heater is going to last much longer. If you make a hole, it may be very difficult or impossible to get the water heater up again, which will end up costing you more money. In the long run, it’s better to make sure that you seal those leaks and holes in the wall.

Leave a Comment